Factory Free sample Squeegee Blades - Emulsion remover for screen printing – Jiamei

Screen printing emulsion remover powder

Product Description

pure Use ratio  Remarks
J.M.H-500 50% 1:100 1 kg of defilm powder mixed with 100kg of water
J.M.M-300 30% 1:65 1 kg of defilm powder mixed with 65kg of water
J.M.N-100 15% 1:45 1 kg of defilm powder mixed with 45kg of water


Save screen mesh.   /Easy to dissolve in water.   / Reduced the cost for the enterprise.  /Membrane cleaned off quickly and cleanly.

 With little damage to the environment.  / Aqueous solution can be long-term preservation.  / Low Price Hot Sale Screen Printing Photo Emulsion Remover



Mixing of Autostrip Powder

For general use dissolve 100 grams in 10 litres (18 pints) of cold water to make 1% strength solution. When stencils are difficult to remove use 5 litres of cold water to make a 2% strength solution. If an Automatic Stripping machine is used a 2% solution strength is preferred for a longer solution life.

Use of Autostrip Powder

1.Remove all ink residues by applying Autosolve Screen Wash to both sides of the mesh and work in with a brush.

2.Wash both sides of mesh with water to remove all solvent traces.

3.With a brush, apply Autostrip liberally to both sides of the mesh.

4.Leave to stand for 3 to 5 minutes while the emulsion coating dissolves. Do not allow Autostrip to dry onto the screen as this will make the stencil difficult to remove.

5.Wash off the stencil with a strong spray followed by a high pressure gun.